Wizard Products List
next product in the category «Inductrial construction» Заглушки для труб→

Priming "GF-021"

GOST: 25129-82
"GF-021" priming is a suspension of pigments and fillers in alkyd paintwork with dissolvents, driers and stabilizing additives.
Contact Person
Sales Department
InterGazSintez

(06453) 6-21-02

(050) 348-77-47

com@igs.ua

Application and Features

  • "GF-021" priming is designed for priming metal, wooden and concrete surfaces.
  • Dry coating is highly resistant to grit and ultraviolet rays. Can be applied both as priming layer in coating systems and as independent coating.
  • Film is tolerant to temperature drops withing the limits of -45 - +60°C.
  • Priming is highly adhesive to metal, wooden and concrete surfaces exposed to drastically changeable atmospheric conditions.
  • Priming is applied by any way of spraying, by a roller or brush, by dipping or jet-stream spilling.
  • Color - red-brown, gray.
Measure and measure unitMeasure value
Apperance of dry film Even, homogeneous, matt or semigloss
Relative viscosity according to V-3 246 viscometer (nozzle diameter 4 mm) under (20±0,5) °С, seconds, no less than  
Nonvolatile substances mass fraction, %, no less than 54-60
Drying time to degree 3 under (20,0±0,5)°C, hours, no more than  24
Drying time to degree 3 under (105 ±5)°C, minutes, no more than 35
Film elasticity, mm, no more than 1
Hardness according to TML pendulum device (pendulum А), standard units, no less than 0,35
Tolerance to static exposure to industrial oil lubricant under 20°С, hours, no less than 48
Tolerance to static exposure to 3 % sea sodium chloride solution under 20°С, hours, no less than 24
Tolerance to nitrocellulose lacquer No choking, shrinking or cracking of nitrocellulose lacquer applied over primer
Polishing capacity Polished film must turn to even surface without greasing sandpaper
Grit, um, no more than 40
Adhesion, points, no more than 1
Resistance to impact, cm, no less than 50
Degree of dilution with dissolvent,%, no more than 20
Recommended layer thickness, um 25-30
Minimal primer consumption for one-layer coating, kg/m², dry coating thickness being 25-30 um 0,06-0,1
Instructions for use

Before applying priming stir it until it becomes smooth paste. After a durative storage, an insignificant exfoliation is possible. For less viscose priming, dilute it with 646 dissolvent, or with solvent, or with White Spirit until desired thickness is obtained.
Priming is applied to dry clean surface under at least 5 °С and humidity no higher than 80%. When applying priming, surface must be at least 3°С warmer than dew point.
This priming is compatible with hot drying (105-110°C, 1 hour).

Packaging, transportation and storage

Packaging is performed according to state standard 9980.3.

Storage is performed according to state standard 9980.5.

Warranty period 12 months after manufactured.

Occupational health and safety

Inflammable. Apply in well-ventilated premises only. Avoid inhaling. Keep away from eyes and skin.