Wizard Products List
next product in the category «Tanks protection» "Синтего-ЭГ"→

Two-component epoxy priming "Sintego-EG"

TUU: 24.6-32803942-011:2007
"Sintego-EG" is a high quality fast drying two-component primer with polyamine solidifier.
Contact Person
Sales Department

(06453) 6-21-02

(050) 348-77-47


Application and Features

  • Notable physical and mechanical qualities, tolerance to dissolvents, fresh and sea water, high and low temperature make this priming recommendable for a broad variety of consumers priming metal surfaces of machinery, metal structures, piping, wooden and concrete articles.
  • Active polyamine solidifier substantially decreases drying time of primer.
  • Priming can be applied under low air temperatures (to 0°С).
  • Material can be used as intermediate layer in coating systems. Adhere to the following scheme: epoxy primer - intermediate layer - final layer.
  • Life service at least 10 years.
  • Can be efficiently combined with epoxy, polyurethane, acryl and alkyd coatings. Recommended to use "Sintego-ЭЭ" epoxy enamel or "Sintego-UR.02" alkyd-urethane coat-enamel for final layer.
Measure amd measure unitMesaure value
Appearance dark red
Nonvolatile substances mass fraction, %, no less than 60
Life service after merging base and solidifier, hours, no less than 4
Relative viscosity according to V3-4, seconds 80-140
Density, g/cm³ 1,4-1,5
Grit, um, no more than 20
Adhesion, points, no more than 1
Elasticity when bent, mm, no more than 2
Resistance to impact, cm, no less than 70
Recommended coating thickness, um, within the limits 20-50
Drying time of a 30 um layer to degree 3 under 25°C (hours, no less than) 1,5
Tolerance to exposure to water (hours, no less than) 72
Tolerance to exposure to 3% sodium chloride solution (hours, no less than) 72
Tolerance to exposure to White Spirit (hours, no less than) 336
Tolerance to exposure to toluol (hours, no less than) 336
Instructions for use

Merge base of priming with polyamine solidifier in 74:1 ratio (mass) and stir thoroughly. Application life of ready blend is 4 hours provided that it is in a hermetic package.
Surface must be prepared in accordance with state standard 9.402 or international standard ISO 8501-1 (to degree Sa 2½ or St 3). In 30 minutes after merging components apply primer by air or non-air spraying, brush or roller. Surface temperature must be 3 °C higher than dew point.
It is advised to make 1-2 layers.

Packaging, transportation and storage

Packaging is performed according to state standard 9980.3.

Storage is performed according to state standard 9910.5.

Warranty period 12 months after manufactured.

Occupational health and safety

Adhere to precautions recommended for work with epoxy materials and solidifiers.
Apply in well-ventilated premises only. Avoid inhaling. Keep away from eyes and skin.